USB+SD MP3 for BMW 10Pin

USB+SD MP3 for BMW 10Pin


USB+SD MP3 for BMW 10Pin Features:

1. Plug&play, CDC alternative
2. Connected with wire harness, not FM signal controlled ,Hi-Fi guaranteed
3. Controlled by vehicle Head Unit, support Steering wheel operation
4. With imported Hi-Fi Decoding Chip, perfectly support MP3 and WMA tracks
5. Supports SD/SDHC/MMC card/U Disk/Card Reader/Hard Disk
6. Supports external audio source(MP3 MP4 PSP Mobile Phone) via AUX in port
7. Playlist function same as multi CDs
8. Supports Last Position Memory (LPM)
9. Vibration and interference proof
10. Easy to install, no damage to original car decorations for different car models or car radios

USB+SD MP3 for BMW 10Pin Work with:

BMW 10PIN
3 series (E46) 1998-2006 ,
5 series (E39) 1995-2003 ,
7 series (E38) 1994-2001,

840 1990-2001 only with existing I-Bus (from about 1997),
850 1990-2001 only with existing I-Bus (from about 1997),
M3 (E46) up to 2001, M5 (E39) up to 2001, Z8 (E52), up to 2001,
X5 (E53) up to 2001, Compact 1994-2001, Mini Cooper, 2001-2006 ,
BMW motor-bike K1200 LT (up to 2004)

Head unit:

BE3350 (Business cassette),
BE3351 (Business cassette),
BE6510 (Professional),
BP8272 (Business CD),
BP9272 (Business CD),
PH7050 (Business cassette),
PH7070 (Business cassette), PH7090 (navigation system), PH7860T (Business RDS),
PH7950 (Business cassette), PH8060 (Business CD), PH9860 (BUSINESS CD RDS),
BMW with monitor, monitor board, Business CD RDS, navigation system, car radio with the 17 pins round
connector

Note:

(1)Speical for BMW Business/Professional/Navigation factory radios
(2)Not compatible with BMW Reverse RDS radio or radios with DSP(Digital Sound Processor) stereo system.
(3)Not compatible with BMW radios without I-Bus (up to 1997)

BMW 10Pin(17-Pin round)Trunk Cable



Available Solutions:

For OEM radios : VW, Audi, Toyota, Honda, Mazda, BMW, Hyundai, Kia, Acura, Lexus, Skoda Citroen,Fiat, Volvo, Mercedes, Nissan, Suzuki, Ford, Renault etc

For after market radios: Clarion ,Alpine, Blaupunkt, Sony, Sanyo, Panasonic, Pioneer, Becker, JVC etc

Installation Guide:

1: Pull out the unit from the car and touch the back of the unit for CDC port when the ignition is switched of.
2: Insert the CDC plug into the original car port correspondingly. Then insert the storage card.
3: Then check if the device works normally or not after power supply given from the car itself.
4: Put the wire harness into the proper and good place after the test successfully.

Packge including:

• Digital CD Changer
• OEM compatible harness to connect to the back of the car stereo
• 3.5 mm Male / Male Audio cable
• Installation manual